Message:

I need to replace my old spa pack that has finally died.  It is a Gecko S class spa pack.  I only have one 2 speed pump and a blower.  Will this replace my old pack.

Thanks Steve

...View Blog >>

Message: Hi, I am looking a replacing my Gulf Coast LX7000 spa pack with your View Blog >>

Message:   I received my new Spa Pack from you last week and will hook it up today.  The only question I have regards the movement of the W1 and W7 wires. I'm will be using a 2 speed pump (230V) ...View Blog >>

Message: I have the Balboa VS501z Hot Tub Heater - VS501 Spa Pack- PN# 54356-03, but I can't find the operating manual for the system.  Where can I get a copy of it? 

Dated on : 04-08-2013

Replies :<...View Blog >>

Message: I recently purchased a Balboa vs501 (fall of 2012) and have just completed the deck and hooked up the gear to energize my tub. It ran through the pr mode and heated to 94 degrees but I could not energize the jets, in facts the jets button didnt seem to work at all. Seems...View Blog >>

Message: We purchased the VS501Z from you in January of 2011. I installed it myself and it has worked pefrectly for two and a half years. Now of course the warranty has expired and we have an issue. It is blowing the main breaker panel GFCI and it cannot be reset. I disconnected ...View Blog >>

Message: The Balboa VS501 board replaced my old board 54585 and I have rewired the board from the factory default setting and have one more question about the extra wire ...View Blog >>